Kropsmateriale : Aluminium Cut-out Mesh Net Material : 304 Rustfrit
Body material: Machined aluminum Mesh net material: 304 stainless steel
*There may be changes in product specifications due to the manufacturer's reasons.
* Billedet er kun vejledende. Den viste billede kan variere fra det faktiske produkt.
● PCRACINGFLOOil Filter er et oliefilter, som nemt kan skilles ad og vaskes og anvendes halvtidsigtigt ved hjælp af 304Snål meshNet udviklet til medicinsk brug.
- Som et bevis på høj ydeevne anvendes den også i 2 hjul RACINGTeam, F1, NASCAR, INDYCAR, rumfartsfelt.
● OEMOil Filter kan kun fjerne Garbage op til ca. 95 Micron, mens FLOOil Filter kan fjerne omkring 35 Micron Garbage og Slam.
● Da det er muligt at passere olieflow på 7 gange eller mere end OEMOil Filter med lavt tryk, er det muligt at undertrykke Power loss af Engine til den mindste Små grænse og udvise stabil magnetisk kraft selv ved høj temperatur "Neodymium Rare Earth Magnet "Standardudstyr, du kan fjerne det fine jernpulver, der ikke kunne fjernes med oliefilteret uden at gå glip af, du kan altid kontrollere garbage og slam? jernpulver der forbliver i filteret for hver olieskift, tag altid mærke til motorens tilstand. Det er muligt at gøre.
● Aluminium Cut-out Body med fin har to gange området OEMFilter og har fremragende køleeffekt.
● Det er muligt at bruge et generelt 17 mm værktøj til installation / fjernelse uden at kræve filternøgle. Da det også har standardudstyr til trådlåsning, er det sikkert, selvom du rejser.. Isoleret på tidspunktet for olieændring Det er miljøvenlig konstruktion, der ikke udløser nogen besværlig ubrændbar garbage.
●The PC Racing FLO Oil Filter uses a 304 stainless steel mesh net developed for medical use, can be easily disassembled and washed, and can be used semi-permanently.
●As a proof of its high performance, it is also used by two-wheel racing teams, F1, NASCAR, INDYCAR, and aerospace fields.
●The stock oil filter can only remove debris down to about 95 microns, while the FLO oil filter can remove debris and sludge down to about 35 microns.
●The oil flow rate is 7 times higher than that of the stock oil filter with less pressure, so the power loss of the engine can be minimized.In addition, "Neodymium rare earth magnet" which shows stable magnetic force even at high temperature is equipped as standard, and the fine iron powder which cannot be removed by the oil filter can be removed without missing, and the condition of the engine can always be grasped because the dust, sludge, and iron powder left in the filter can be checked at every oil change. Checking the condition of the engine can be done.
●The body with machined aluminum fins has twice the area of the stock filter for superior cooling effect.
●A standard 17mm tool can be used for installation and removal without the need for a filter wrench.It is also equipped with a hole for wire lock as a standard feature, so it is safe for circuit riding.It is an environment-friendly structure that does not produce any noncombustible garbage that is difficult to dispose of when changing the oil.
Advarsel
* If there may be an instruction manual included, it will be written in Japanese.
I'm using it with the TRX850 Unlike other models, this is only for Element It was just an easy installation It's the same treatment as a normal oil element, and it's a large and sturdy oil element The quality of the stainless steel mesh feels good It is a fine mesh, so iron powder and Garbage can be removed firmly I cleaned it carefully with Bucket+ kerosene and applied Parts cleaner and Oil It is attached by hand (It's Large sturdy with Parts cleaner for cleaning only...) After using it, the Engine output is now Mild To tell the truth, it was a change at the place where I thought it was power down for a moment It was easy, but the main thing is that the valleys at the RPMs that have an output characteristic suddenly became calm Is it as the Manufacturer's Oil pump load reduction effect is advertised? There's a feeling that Mild has lost its Stress and acceleration when you run the Machine I felt the lightness of the Machine from the way the power of the power of the The sensation does not change after a while of use, and even if the type and viscosity of the oil are different, the impression is the same, so it is not as bad as it used to be I don't think so Furthermore, the change of oil is a little easier, the change of the proper amount of oil after refilling is now It is a little easier to check the oil level It's durable and it pays off if you think you've replaced it five times, so it's not too bad for the costView Detail
I installed it in KSR Until now, it was an ordinary oil filter outside the company, but with seven times the flow rate of such a filter I bought it because I thought it would reduce Friction of Oil To some extent, the response is better cleaner, so it's going to be semi-permanent, and Racer is going to be able to use even a fraction of 1% of this I think the filter is installed to increase the power, but you know what I mean I recommend it to people who are particular about the performanceView Detail
It is used only by CRF 250 R, but it was for the first time in 2014 formula for use and it was purchased for 2010 formula this time. Though purchased three years ago, the Rubber's Size was somewhat loose, this time there was a Gap of the turning axis of the Aluminum part in the Filter, but both are cleaning to the extent that performance is not problematic, every time Oil is exchanged It is dirty securely!View Detail
* The BEST and MUST store to find Japanese parts. * Register now for amazing deals and other special offers! *Over 800,000 listed items. It's hard NOT to find your parts.
SIGN IN TO WEBIKE JAPAN
Please enter email at least 6 characters.
Please enter a valid email address.
Email is already in use.
Your account has been banned.
Email address and/or password is not match.
Authentication with facebook fail.Please try again.
Please select How did you get to know about Webike Japan?
OR
YOUR ACCOUNT HAS BEEN CREATED!
Congratulations! Your new account has been successfully created! You can now take advantage of member privileges to enhance your online
shopping experience with us. If you have ANY questions about the
operation of this online shop, please email Webike through CONTACT US.
A confirmation has been sent to the provided email address. If you
have not received it within the hour, please contact us.
Get on your grid by register your motorcycle! About our "Mybike" service
"Easier to Search Items" It helps you to search items to fit for your motorcycle!
"Get Much Valuable Information" It helps you to get special deals, newly listed items and closeouts about your motorcycle!
"Easy to Register" It requires only your motorcycle manufacturer, model name and model year!