Stomp Grip er patroniseret af Top racer, Tops Tan Rider fra forskellige lande over hele verden.
Japans Circuit, STREET modtog også stor popularitet.
STOMP GRIP-brugere stiger over hele verden.
[Sådan anbringes stub Grip]
1. Rengør applikationsoverfladen.
(Hvis du bruger [Colour] Clear, skal du arbejde efter at have snappet og snavset vandskrabe rent sammen med Compoundetc.)
2. Afrens applikationsoverfladen.
3. Udfør positionering.
4. Venligst indsæt fra kanten, så der ikke kommer luft ind. Skal forsynes med bagpapiret, mens du holder det fast.
(Indsæt langsomt lidt efter lidt fra tid til anden)
Det tager 24 timer, før stompgrebet stabiliseres.
Der kræves 72 timer til fuldstændig vedhæftning.
Når den bruges før fuldstændig limning, kan det falde af, eller det kan være forkert.
* Vær særlig opmærksom på den stempelprop, der sidder fast på rammen.
STOMP GRIP is used by top racers and top stunt riders all over the world.
It is very popular in the circuit and the street in Japan.
The number of users of STOMP GRIP is increasing all over the world.
[stomping on stomp grips]
1. Clean the surface to be applied.
(When using clear, please remove dirt and water stains with compound before starting work)
2. Degrease the surface to be applied.
3. Perform positioning.
4. Apply from the edge so that air does not enter.Peel off the backing paper while pasting.
(Take your time and apply slowly from the edge, little by little)
It takes 24 hours for the adhesive strength of Stomp Grip to stabilize.
Full adhesion requires 72 hours.
If you use the product before it is fully bonded, it may peel off or shift.
*Please pay special attention to the stomp grips that are attached to the frame surface.