* Dette produkt er cirka 65 mm tilbage og 3 mm lavere i højden end lagerhåndtaget.
* Den samlede bredde er -5 mm i slutningen af lagerhåndtaget. (Samlet bredde: ± 20 mm / samlet højde: ± 40 mm) Ingen strukturændringer er påkrævet.
* Der er ikke behov for at skifte slange / sele / ledning til dette produkt, men hvis du er bekymret for det, skal du skifte bremseslange til den passende længde. Juster akseltrådens spænding på grund af ændret håndtering.
* Der er en fejl i tykkelsen af malingen på dette produkt. Når du drejer akselsiden, kan den være kedelig. I dette tilfælde er det nødvendigt at justere gashåndtaget på styret ved at barbere med en fil.
* Stempelmærkerne på dette produkt er kun til reference. Juster placeringen af håndtaget efter din smag.
* Der er en sag, at hullet i kontaktboksen til dette produkt er lidt ude af justering. I et sådant tilfælde kan det være nødvendigt at ændre det ved at udvide hullet. Hvis du er en person, der er ubehagelig over installationen, eller hvis du er nervøs for arbejdsomkostningerne og processen, anbefaler vi dig at konsultere Honda Dream-butikken på forhånd.
* Bemærk, at produktspecifikationen kan ændres på grund af producentens årsager.
[Size*] W: 710 H: 100 R: 200 L: 130
[Handle diameter] 1 inch (25.4mm)
*W (Overall width) H (Height) R (Amount of pullback) L (Clamp section straight) Unit (mm)
*This product is approximately 65mm back and 3mm lower in height than the stock handle.
*Overall width is -5mm at the end of the stock lever.(Full width: ±20mm / height: ±40mm) No structural changes are required.
*This product does not require any changes to the hoses / harnesses / wires, but if you are concerned, please change the brake hoses to an appropriate length.Adjust the tension of the axle wire due to the changes in handling.
*The thickness of the paint on this product may vary.There may be a dullness when turning to the axle side.In this case, it is necessary to adjust the throttle sleeve side of the handlebar by shaving with a file.
*The punch marks on this product are for reference only.Please adjust the position of the handlebar to your liking.
*The holes in the switch box of this product may be slightly out of alignment.In this case, it is necessary to widen the hole.If you are a person who is finicky about bolt-on installation, or if you are nervous about the labor cost and process, it is recommended that you consult with your HONDA Dream shop beforehand.
*There may be changes in product specifications due to the manufacturer's reasons.