- I think this product is cheaper and more cost-effective than other companies' products.Læs mere
- ZX-10R [24] mounted onFront of 10R is very luxurious even for OEM with brembo and SHOWA.Damage to the equipment when it stands up and falls over will require significant repair costs,I put it on as a ...Læs mere
- I'm going to install it with the idea that it will look a little better before it falls down.Læs mere
- For Triumph TRIDENT, Babyface Front axle protector was installed on Tigersport 660 as well as Engine slider.Although less expensive than OEM products, the appearance and quality of the parts are good,...Læs mere
- This is my first Return in 20 years, so I bought it to prevent standing moss!Torque wrench is required as 5Nm is indicated for screw tighteningI didn't have one, so I bought a Torque wrench, but I did...Læs mere
- I have an external caliper, so I installed it to avoid damaging it as much as possible. It is not as aggressive as the rear slider and does not look bad after installation. It will be installed withou...Læs mere
- 다른 프런트 액슬 프로텍터랑 고민많이 하고 선택했는데 아주 만족합니다.우선 가격이 아주 합리적입니다. 거기다 상품성도 우수합니다. 구입하신다면추천드립니다. 아기얼굴로 23년 카타나를 잘 지켜주리라 믿습니다. 리어 액슬프로텍터도 나오면 좋겠는데 아무리 찾아도 없더군요
-----------------------------------------------...Læs mere - I had used it on another car before and it protected me well when I crashed on the Circuit, so I put it on this car as well (the slit in the middle cracked because it protected the car body so well......Læs mere
- [How is it used?City Riding, Touring MainCircuit not runningWas the one you received as per Image?No different than the Image in the photo.Simple, but easily recognizable as a Babyface product, so I l...Læs mere
- Since the company's Protector was installed to protect the Axle on the Rear side, I purchased one for the Front side as well. However, as with the Rear side, the Axle Shaft was replaced with a KOOD on...Læs mere
- Because I wanted to arrange it in the whole Black tone, I unify it with Babyface. it is a casual departure choice because Mask is unique. I don't know the effect because I don't mock, but it seems to ...Læs mere
- I used a 10mm box wrench and an extension bar to tighten it while holding the One Side. I was not sure whether to install it or not because the wheel is lighter, but I am glad I did. I bought it as an...Læs mere
- Circuit Because I drive, I installed it in preparation for falling.I have not tried it yet, but at the time of falling Front ASKUL and Front forketc. I hope to protect you.In addition, I think that ap...Læs mere
- I installed it in 2015 RC390.There is no manual by car type, but I think that there is no special difficult thing.Body Right Side has a Screw hole in Axle Shaft so there.The car body Left Side will be...Læs mere
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING